FHBS standard curing room fully automatic temperature and humidity control equipment

1. Product Overview

The FHBS standard curing room fully automatic temperature and humidity control equipment is a specialized device used for standard curing of building materials samples such as concrete test blocks and cement specimens. It meets the requirements of GB/T 50081-2019 “Test Methods for Physical and Mechanical Properties of Concrete” and ISO standards for the curing environment (temperature 20 ± 1 ℃, humidity ≥ 95%). Through an intelligent control system, precise adjustment of temperature and humidity is achieved to ensure consistency in the curing conditions of the specimens.

2.  Core functions

• Fully automatic control: using microcomputer PLC or touch screen control, automatically adjusting temperature and humidity without manual intervention.
• Dual system regulation: dual-mode temperature control for cooling/heating: compressor cooling+electric heating tube heating, quickly stabilizing temperature.
• Ultrasonic humidification: High frequency atomization humidification, with uniform humidity and no condensation of water droplets.
• Data recording and alarm: It can store historical data and support sound and light alarms for abnormal situations (such as power outages and exceeding limits).
• Energy saving design: equipped with a circulating air system and insulation layer to reduce energy consumption.

3.  Technical parameters

4. Operation process

• Installation and debugging: The equipment is installed in the maintenance room, ensuring good sealing around and no leakage in the pipeline.
• Power on settings: Set the target temperature (20 ℃) and humidity (95%), and start the automatic operation mode.
• Daily monitoring: Observe real-time temperature and humidity through the display screen, and regularly check the water level in the water tank.
• Placement of test pieces: interval between test pieces ≥ 10mm, avoid direct contact with spray nozzle.

5. Maintenance and Precautions

• Regular maintenance:
  1. Clean the water tank and filter to prevent scale from clogging the humidifier.
  2. Check the sensitivity of the sensor and calibrate it if necessary (recommended every 6 months).
• Fault handling:
  1. Insufficient humidity: Check if the humidifier is working and if the water source is sufficient.
  2. Large temperature fluctuations: Confirm the operating status of the compressor or heating tube, and check the sealing of the insulation layer.
  3. Safety reminder: The equipment should be grounded to prevent leakage and avoid direct operation of circuit parts in humid environments.

6.  Application scenarios

• Construction Quality Inspection Center
• Cement/concrete production enterprise laboratory
• Materials laboratory of universities and research institutions